20 PCS – 5 Volt 7 Ampere SPDT PCB Mount Relay
SPDT(Single Pole Double Throw) relay is used as a switch for high current AC/DC appliances which need to be controlled from a microcontroller or sensor output. 5V PCB Mount Sugar Cube SPDT Relay instead of its small size can switch a load of 7A connected to it. The coil resistance of this relay is 70 ohm whereas the coil current is 70mA. The trigger voltage for this relay is 5V.
Description
There are 5 pins in this relay i.e, Coil end 1, Coil end 2, COM(common), NC and NO. Coil end 1 and Coil end 2 are used to trigger ON/OFF the relay. One end is connected to a 5V supply and the other is connected to the ground of the circuit. Common is connected to the one end of the load to be controlled. The other end of the load is connected to either NC or NO. If the load is connected to NC(Normally Closed) then the load remains ON before trigger. And if it is connected to NO(Normally Open) then the load remains OFF before trigger. These relays are usually used in home automation, switching circuits, security circuits, etc.
SPECIFICATIONS
Maximum AC load current | 7A @ 250/ 10A @ 120V AC |
Maximum DC load current | 12A @ 120/ 10A @ 24V DC |
Trigger Voltage (Voltage across coil) | 5V DC |
Trigger Current (Nominal current) | 70mA |
Operating time | 10msec |
Release time | 5msec |
Additional information
Weight | 0.25 kg |
---|---|
Dimensions | 1.9 × 1.5 × 1.5 cm |
Reviews (0)
Recommended for you
1 Channel 5v 10A Relay Control Module without Optocoupler High Low Level Trigger Electronic Components
12V 10A PCB Mount Sugar Cube Relay – SPDT
5 Volt 10 Ampere SPDT PCB Mount Relay
Pack of 2 – 12V 10A PCB Mount Sugar Cube Relay
5V 7A 5 Pin SPDT subminiature High Power Relay
4 Channel 5V Relay Module with Optocoupler
Latest products
-
5
AT24C256N I2C EEPROM Memory Module
Nano Board R3 with CH340 Chip Mini-USB Port compatible with Arduino (Unsoldered)
-
5
L293D Motor Driver Shield for Arduino
NRF24L01 antenna V5.0 + PA + LNA SMA wireless Module 8 Pin 1100 meters
NRF24L01 2.4GHz Wireless Transceiver Module
-
5
LM393 Optical Photosensitive LDR light sensor module for Arduino Shield DC 3-5V
-
0
Reviews
There are no reviews yet