FS1000A 433mHz Transmitter & Receiver RF Radio Module
This is FS1000A 433mHz Tx & Rx RF Radio Module. This RF module comprises an RF Transmitter and an RF Receiver. The transmitter/receiver (Tx/Rx) pair operates at a frequency of 433 MHz. An RF transmitter receives serial data and transmits it wirelessly through RF through its antenna connected at pin4.
Description
The transmission occurs at the rate of 1Kbps – 10Kbps. The transmitted data is received by an RF receiver operating at the same frequency as that of the transmitter.
This low-cost RF transmitter can be used to transmit signals up to 100 meters (the antenna design, working environment, and supply voltage will seriously impact the effective distance). It’s good for a short distance, battery power device development. 433 MHz is the operating frequency for transmitter and receiver pair.
Features :
- Wide input supply (2.5 V to 12V)
- Easy to integrate (V+, GND, and Data)
- The device in deep sleep mode when Data pin is grounded
- Very small dimension.
Receiver Module specification
Operation voltage: DC5V
Static Current: 4MA
Receiver frequency: 433.92MHZ; 315 Mhz
Sensitivity:-105DB
Dimension:30*14*9mm
External Antenna:32CM signal wire,spiral
Transmitter Module Specification
Operating voltage: 3-12V
Operating frequency: 433.92MHz; 315Mhz
Standby current: 0mA
Operating current :20-28mA
Transmission distance:> 500m (open to receiving plate sensitivity at-103dBm distance of more than)
Output Power: 16dBm (40mW)
Transfer rate: <10Kbps
Modulation mode: OOK (Amplitude Modulation)
Operating Temperature: -10 ℃ ~ +70 ℃
Size: 19 × 19 × 8mm
Package Includes :
1 x FS1000A 433mHz Transmitter.
1 x FS1000A 433mHz Receiver.
Additional information
Weight | 0.1 kg |
---|---|
Dimensions | 15 × 10 × 2 cm |
Reviews (0)

Recommended for you
NRF24L01 antenna V5.0 + PA + LNA SMA wireless Module 8 Pin 1100 meters
NRF24L01 2.4GHz Wireless Transceiver Module
MFRC-522 RC522 RFID RF IC card reader sensor module + 1 card
Latest products
PIR Motion Detector Appliance Control Kit
NODEMCU – ESP8266 Wifi Development Board with Micro USB Cable – 100 CM
Arduino UNO R3 SMD Atmega328P Board with Cable (USB A to B) – 30 cm- Clone Compatible Model
Nano Board R3 with CH340 Chip Mini-USB Port compatible with Arduino (Unsoldered) with cable – 50 CM
-
0
XH W1209 12V Digital Temperature Controller Module W/ Display and NTC Temp Sensor
-
0
Micro USB Cable for Raspberry Pi/ESP32/NODEMCU-1M
-
0
Cable For Arduino Nano USB A to MINI B (Nickel Plated Connector)-50CM
-
0
Reviews
There are no reviews yet